196LRCS Medium Duty V-Belt Driven Live Roller Curve Spurs

TREAD ROLLERS: 2-1/2” dia. to 1-11/16” dia. x 14 ga. tapered rollers (model 254T); 1.9” dia. x 16 ga. (model 196S) straight tangent rollers.

PRESSURE SHEAVES: Provides drive belt pressure to upper tread rollers.

BELT: “B” section V-belt.

TAKE-UP: Screw type adjustable sheave with flat idler sheaves provided to maintain belt tension.

TANGENTS: 12” opposite spur end on 60/30 unit; 18” opposite spur end on 45/45 unit.

BED: 7” x 1-1/2” x 12 ga. formed steel channel frame.

BEARINGS: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed.

SPUR HAND/dRIVE LOCATION: Drive located on outside of curve. Specify hand of spur as “left hand” or “right hand” and location of drive specified as “left hand drive” or “right hand drive”. NOTE: Drive location determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.

BELT SPEED: 60 FPM, constant.

ROLLER CHAIN: Drive shaft is driven by No. 50 chain.

CAPACITY: 500 lb. total distributed live load.

ELECTRICAL CONTROLS: Optional.

SIDE MOUNTED END DRIVE: Provides minimum overall conveyor height of 10”.

DRIVE: Located on inside radius of curve.

MOTORS: Available through 3 HP in TEFC, explosion proof, dirty duty, brake motor, 115/230/1, 575/3, etc.

SPEED: Constant speed 10-120 FPM; DC variable speed; AC inverter variable speed. Other constant or variable speeds available.

CEILING HANGERS: 5/8” dia. threaded rod with hardware to attach rods to conveyor. Provides 6’ clearance between ceiling and TOR (furnished in place of floor supports). See Conveyor Accessories.

GUARD RAILS: 1-3/4” x 1” formed channel (model GC), adjusts horizontally to 8” wider than roller and vertically to
6” above roller; formed steel fixed (model FSG in 2”, 4”, 6”, 8”, 12” and 18” heights; 1-1/2” angle (model GA1-1/2). See Conveyor Accessories.

ELECTRICAL CONTROLS: Magnetic starter (one direction or reversible); One direction manual starter; Momentary start/stop push button station; For-ward/reversing /stop push button station.

FLOOR SUPPORTS: See Conveyor Accessories for various elevation and types.